Please read the safety and compliance information below before purchase and installation.
Battery Safety Warning Important
This product may contain a button or coin cell battery.
WARNING: Button and coin cell batteries can cause serious injury or death if swallowed or inserted into the body.
- Keep new and used batteries out of reach of children at all times.
- Do not use the product if the battery compartment is damaged or does not close securely.
- Dispose of used batteries immediately and safely — even flat batteries can cause harm.
- Do not ingest the battery — chemical burn hazard.
- If you suspect a battery has been swallowed or inserted, seek urgent medical attention immediately — severe or fatal injuries can occur within 2 hours.
Emergency Contacts
- Australia: Poisons Information Centre — 13 11 26
Compliance & Installation Responsibility
All products supplied are manufactured and certified by the original manufacturer to meet relevant Australian Standards, based on manufacturer documentation available at the time of supply.
We provide product information and general guidance based on manufacturer specifications only. We do not provide engineering advice, site assessments, installation services, wiring guidance, or regulatory compliance certification.
Installation, electrical work, site suitability assessment, and ongoing compliance with applicable standards and regulations remain the responsibility of the installer or purchaser.
Product Selection & Use
Product suitability depends on correct selection, installation, and use in accordance with the manufacturer’s instructions and applicable standards.
It is the responsibility of the purchaser or installer to:
- Verify the product is suitable for the specific gate, site conditions, and power supply.
- Confirm compliance with all relevant local, state, and national regulations.
- Ensure installation is performed by a suitably qualified person where required.
We do not accept responsibility for product performance or suitability where products are installed or used outside of manufacturer specifications.